NEW DURO DYNE GBAC ADHESIVE APPLICATOR
The GBAC applies Duro Dyne WIT or WSA water base adhesive to insulation in preparation for application to sheet metal. It requires 110v service fused for 15 amps. A source of air is required. Specify the direction of work flow when ordering.
The GBAC applies Duro Dyne WIT or WSA water base adhesive to insulation in preparation for application to sheet metal. It requires 110v service fused for 15 amps. A source of air is required. Specify the direction of work flow when ordering.
The GBAC applies Duro Dyne WIT or WSA water base adhesive to insulation in preparation for application to sheet metal. It requires 110v service fused for 15 amps. A source of air is required. Specify the direction of work flow when ordering.
FAST- The GBAC is capable of coating fiberglass duct liner at the rate of 52’ per minute. Using a standard roll of material - 5’ wide, the GBAC coats over 250 square feet of liner per minute.
VERSATILE - GBAC’s are quickly adjusted to accept liner ranging for 1/2 to 2 inch thickness.
EASY TO USE - The Roto Bonder pumps water base adhesive from a drum into a built-in storage tank. A circulating system maintains proper adhesive level. Simply turn on the power and feed the liner material into the GBAC. There is no over spray or dangerous solvent fumes.
FAST CLEANUP The GBAC cleans with plain water in minutes. All parts are easily accessible to the operator.
HIGH PRODUCTION The GBAC works with existing Insulation Sizing machines and can be used in conjunction with an Automatic Pinspotter for a low cost high efficiency production line.
ROTO BONDER - The Roto Bonder is a machine designed specifically for the purpose of roller coating one side of duct liner with adhesive prior to joining to the metal section of the duct. Insulation up to 60” wide can be evenly coated at a rate of 52’ per minute. Either Duro Dyne’s WSA or WIT adhesive can be used. Both are water base non-flammable adhesive and are available in 55 gallon drums or 5 gallon pails. The Roto Bonder contains a trough through which the lower of two rollers rotates. The lower roller picks up adhesive, the thickness of which is controlled accurately by an adjustable metering bar. The Roto Bonder accepts insulation thickness of 1/2 to 2 inches.
OPERATION - Turn the multi port valve so that adhesive flows from the 60 gallon storage tank into the trough. Re-set the valve to circulate the adhesive from the tank to the trough and feed pre-cut liner material into the machine. In seconds, adhesive coated fiberglass automatically moves across the exit fingers. At the end of the work day, pump adhesive from the trough to the storage tank. To clean the rolls, metering bar, trough and exit rack, sponge them with water. By eliminating spraying, there is no longer any hazard of fire and dangerous fumes, No venting of fumes is necessary. Clean-up is fast and easy. When the Roto Bonder is used in conjunction with a Liner Sizing machine and Pinspotter, it is possible for one man to perform the entire operation of adhering and pinning liner to duct sections
A heavy duty low maintenance air operated pump. A metering bar accurately controls adhesive application. Easy access multi-port ball valves control adhesive flow. The cleanup position leaves sufficient space between the upper roll and the adhesive roll to allow for easy cleanup without endangering the operator.
A stainless steel trough provides dependable rustproof service.
A 60 gallon covered storage tank is built into the Roto Bonder. Safety guards are designed for maximum safety and practical shop use.