(1) Rohner # BOHT-SLWP-10-10-20-SMI, Industrial Batch Oven-High Temperature
Return Plenum- return air inlet located at top of process heater
Discharge Plenum- two lower side wall plenums will discharge heated air toward the center of the oven creating a mixed flow
Process Heater- Rear Mounted
Working Dim: 10'-0" W x 10'-0" H x 20'-0" D
Overall Dim: 12’-8" W x 11’-4” H x 26’-6" D (Dimensions confirmed during approvals)
Product doors: (1) Set of insulated product doors 10’-0” W x 10’-0” H clear opening
Temperature: 160 – 450 deg. F (500 deg. F maximum)
Burner input: 1.5 Million BTUH
Product Capacity: 10,000 pounds of steel per hour
Circulation Blower: 14,000 CFM; 10hp. for a minimum of 6.5 air turnovers per minute.
Exhaust Blower: 800 CFM; .5 hp, sized for 2 gallons of solvent per hour
NOTE: All dimensions are approximate and will be verified on approvals.
· Oven panel construction- double skin 20 GA aluminized sheet steel cold formed and mechanical cinched. Panels are formed with a tongue and groove joints and are perforated to reduce heat loss. Panels are insulated with 4" 4lb. density mineral wool. Explosion relief will be incorporated in the top or side wall panels as required by NFPA 86.
· Oven structural support fabricated from welded tube steel frames located on the exterior of the oven for a smooth cleanable interior surface. Structural components are pre-punched for nut and bolt field assembly, NO FIELD WELDING REQUIRED.
· Discharge plenum(s)- 18 GA aluminized sheet steel cold formed panels. Sections are shop preassembled, ready for modular field assembly. Plenum faces are perforated with adjustable “H” pattern orifices for even heat and air distribution.